Tips

How to clean a fur collar at home

A fur collar is a unique accessory. It not only decorates outerwear, but also protects a fashionista from adverse weather conditions. However, fur loses its attractiveness very quickly, especially if it is not taken care of at all. Therefore, it is necessary to periodically clean a fur collar at home.

Dust

If a coat or jacket with a fur trim has not been used for a long time and has simply hung in a closet, they are unlikely to have become very dirty. However, fine dust may have settled between the villi, which needs to be knocked out. To do this, take a damp sheet and lay it out on any horizontal surface. Place your outerwear on it so that the fur is at the bottom. Next, tap the collar with a small stick. The fabric will absorb the dirt, and the fur part will look like new.

Cleaning the fur will be even easier if your vacuum cleaner has a soft brush attachment. Gently run it over the pile, turning the device on at minimum power.

  1. 10 ways to clean a fur collar
  2. In order to tidy up a fur product, use one or more of the recipes below.
  3. Take river sand, sift it through a sieve, removing various impurities. Next, heat it up and rub it into the pile in a circular motion. Leave the collar for a while so that the dirt is absorbed into the sand. Then shake the fur product thoroughly.
  4. For this method, you will need sawdust from hardwood trees. Mix them with gasoline and treat the collar with the resulting mixture.How to clean a fur collar at home
  5. Skip to content
  6. Wash
  7. Ironing
  8. Stains
  9. Cleaning
  10. Things

Technique

Storage

Dishes

Interior

Garden

How to clean a fur collar at home

A fur collar is a unique accessory. It not only decorates outerwear, but also protects the fashionista from adverse weather conditions. True, fur loses its attractiveness very quickly, especially if you don’t take care of it at all. Therefore, it is necessary to periodically clean your fur collar at home.

  • Dust
  • If a coat or jacket with a fur trim has not been used for a long time and was simply hanging in the closet, it is unlikely to become very dirty. However, fine dust could have settled between the fibers and needs to be knocked out. To do this, take a damp sheet and lay it on any horizontal surface. Place the outerwear on it so that the fur is at the bottom. Next, tap the collar with a small stick. The fabric will absorb dirt, and the fur piece will look like new.
  • Cleaning fur will be even easier if your vacuum cleaner has a soft brush attachment. Gently run it through the pile, turning on the device at minimum power.
  • 10 Ways to Clean a Fur Collar
  • To put your fur product in order, use one or more of the following recipes.
  • Take river sand, sift through a sieve, removing various impurities. Next, heat it and rub it into the pile in a circular motion. Leave the collar on for a while to allow the dirt to soak into the sand. Then shake the fur item thoroughly.
  • For this method you will need sawdust from hardwood trees. Mix them with gasoline and treat the collar with the resulting mixture.When the fuel vapors have evaporated, remove the sawdust from the fur using a soft brush.
  • You will need starch (potato starch is best), talc, semolina, or crushed chalk. Rub any of the listed agents onto the fur collar with your hands. These substances absorb grease and moisture well, and can even be used to clean light-colored fur. Shake the product periodically during the procedure.
  • Pour 1 liter of warm, but not hot, water into a container and add a tablespoon of any shampoo or dishwashing liquid. Stir until thick foam forms and treat the dirty area with the resulting solution. After a quarter of an hour, rinse the fur product in cool water and lay it out on a clean cloth to dry.

If the dirt is not too strong, you can use table vinegar. Dilute it with cool water in a ratio of 1:5 and pour it into a spray bottle. Spray the pile with vinegar essence, lightly sorting it with your fingers, and then wipe with a clean napkin. To keep the attractive appearance of the collar as long as possible, at the end of the procedure, you can treat it with glycerin from a spray bottle in the same way.

Evenly spread the wheat bran on a baking sheet in a not too thick layer. Put it in the oven at a temperature of 60-80 degrees. After 5 minutes, take it out, mix and sprinkle it on the fur product.Rub the collar in both directions, and then carefully comb with a brush.

If traditional methods are not to your liking, you can use household chemicals. This does not mean shampoo, but various stain removers. True, they can only be used in the case of undyed fur. It is also necessary to read the instructions and check the expiration date.

How to clean fur yourself and restore the shine of a fur product?

If it doesn't come off

Before cleaning, no matter which method is chosen, the fur part must be unfastened from the clothing. What if this is impossible? In this case, regular machine washing using household chemicals, such as powder or gel, is allowed. You should choose exclusively gentle programs without spinning. You need to squeeze out fluffy products with your hands very carefully, without twisting them.

Cleaning fur from yellowness

It's not just dirt and fat deposits that prevent your collar from looking attractive. Over time, light-colored pile may acquire a yellowish tint, which spoils the aesthetic appearance of the product.

In some cases, you can save yellowed fur with hydrogen peroxide diluted in water (about a glass of water is required for one bottle). Treat the pile with a cotton swab dipped in liquid. To dry, hang the item in the sun, this will enhance the bleaching effect.

Cleaning a hat at home - keeping the fur beautiful

housewield.tomathouse.com

Try cleaning your fur product yourself. Moreover, now you have a whole arsenal of recipes and useful tips for this. All products are quite inexpensive, and most of them can easily be found in any home.

I like